Product Categories

Social Media

Home > News > Content
What Happens To The Hydraulic Press Brake That Needs To Be Done For Disposal
- Aug 07, 2017 -

  What happens to the Hydraulic Press Brake that needs to be done for disposal

  The Hydraulic Press Brake is an important Hydraulic Press Brake device that is the whole process of the Hydraulic Press Brake when the machine is stopped. In general, the Hydraulic Press Brake is only a small component installed on the device, but because it is too important, it can be said to be related to the safety of the construction and the personal safety of the staff, must be taken seriously. So in the daily work of each shift of the staff need to be checked, so that the Hydraulic Press Brake can be normal operation.

  But the Hydraulic Press Brake is used too long, it will inevitably be a variety of problems, such as: Hydraulic Press Brake wheel damage, Hydraulic Press Brake pads or Hydraulic Press Brake pads wear, work during the Hydraulic Press Brake overheating. These will cause the Hydraulic Press Brake to run erratically and even affect the safety of the work, so the Hydraulic Press Brake should pay attention to these problems, when the following conditions should be done when the scrapped. (1) crack; (2) Hydraulic Press Brake belt or Hydraulic Press Brake pad friction pad thickness of 50% of the original thickness of the original; (3) spring plastic deformation; (4) hinge small shaft or shaft hole diameter wear the original diameter (5) Hydraulic Press Brake wheel should be scrapped when one of the following conditions occurs: ① crack; ② lift, luffing mechanism of the Hydraulic Press Brake wheel, flange thickness of the original thickness of 40%; ③ other institutions Hydraulic Press Brake wheel, the thickness of the wheel thickness of the original thickness of 50%; ④ torsional unevenness of 1.5mm, if the repair, after the repair of the rim thickness should meet the requirements of this Article ②, ③.

  The same time as

  The specific procedure and requirements for installing the frequency converter on the Hydraulic Press Brake.

  Motor selection with Hydraulic Press Brake The basic requirements for matching the drive The motor selection motor with Hydraulic Press Brake must be either a regenerative Hydraulic Press Brake signal processing unit or a regenerative Hydraulic Press Brake signal processing unit as an optional part.

  At the same time, in order to motor positioning, emergency stop and stop when the maintenance, should generally be used with mechanical Hydraulic Press Brake motor.

  Frequency control system on the Hydraulic Press Brake power supply connection requirements:

  Hydraulic Press Brake power must be connected to the input of the inverter, because the output voltage of the inverter is low voltage at low speed, so the suction of the electromagnet will be weakened and the Hydraulic Press Brake will be released. This is not allowed.

  Therefore, the voltage of the Hydraulic Press Brake can not be the same as that of the motor.